FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62754EN/01
260
- When bit 2 (CCN) of parameter No. 5003 is set to 0
Reference position or floating reference
position=Intermediate position
Start–up
O×××× ;
G91 G41_ ;
:
G28 X40. Y–40. ;
:
(G41 G01)
r
r
ss
G00
G01
G28/30/30.1
s
- When bit 2 (CCN) of parameter No. 5003 is set to 1
[FS15 type]
(G41 G01) s s
G00
G01
G28/30/30.1
s
r
Reference position or floating reference
position=Intermediate position
- When bit 2 (CCN) of parameter No. 5003 is set to 0
Reference position or floating reference
position=Intermediate position
Start–up
O×××× ;
G91 G41_ ;
:
G28 X40. Y–40. ;
:
(G41 G01)
r
s
G00
s
r
G28/30/30.1
G01
- When bit 2 (CCN) of parameter No. 5003 is set to 1
[FS15 type]
Reference position or floating reference
position=Intermediate position
(G41 G01)
r
s
G00
s
G28/30/30.1
G01
S G28, G30, or G30.1
command in offset mode
(with movement to a
reference position not
performed)
S G28, G30, or G30.1
command in offset mode
(with no movement)

Leave a Reply

Your email address will not be published. Required fields are marked *