FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
16. CUSTOM MACRO
B–62754EN/01
277
(b)Operation
< vacant > is the same as 0 except when replaced by < vacant>
When #1 = < vacant > When #1 = 0
#2 = #1
#
#2 = < vacant >
#2 = #1
#
#2 = 0
#2 = #1*5
#
#2 = 0
#2 = #1*5
#
#2 = 0
#2 = #1+#1
#
#2 = 0
#2 = #1 + #1
#
#2 = 0
(c) Conditional expressions
< vacant > differs from 0 only for EQ and NE.
When #1 = < vacant > When #1 = 0
#1 EQ #0
#
Established
#1 EQ #0
#
Not established
#1 NE 0
#
Established
#1 NE 0
#
Not established
#1 GE #0
#
Established
#1 GE #0
#
Established
#1 GT 0
#
Not established
#1 GT 0
#
Not established
With the two–path control, macro variables are provided for each tool
post. Specifying parameter Nos.6036 and 6037 allows some of the
common variables to be used for all tool posts.
D Custom macro variables
common to tool posts
(two–path control)

Leave a Reply

Your email address will not be published. Required fields are marked *