FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
16. CUSTOM MACRO
B–62754EN/01
278
VARIABLE O1234 N12345
NO. DATA NO. DATA
100 123.456 108
101 0.000 109
102 110
103 ******** 111
104 112
105 113
106 114
107 115
ACTUAL POSITION (RELATIVE)
X 0.000 Y 0.000
Z 0.000 B 0.000
MEM **** *** *** 18:42:15
[ MACRO ] [ MENU ] [
OPR ] [ ] [ (OPRT) ]
D When the value of a variable is blank, the variable is null.
D The mark ******** indicates an overflow (when the absolute
value of a variable is greater than 99999999) or an underflow (when
the absolute value of a variable is less than 0.0000001).
Program numbers, sequence numbers, and optional block skip numbers
cannot be referenced using variables.
Example:
Variables cannot be used in the following ways:
O#1;
/#2G00X100.0;
N#3Z200.0;
D Displaying variable
values


Leave a Reply

Your email address will not be published. Required fields are marked *