FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
1. GENERAL
B–62754EN/01
12
The tool moves along straight lines and arcs constituting the workpiece
parts figure (See II–4).
Program
G01 Z...;
Tool
Z
X
Workpiece
Fig.1.1 (a) Tool movement along the straight line which is parallel to Z–axis
Program
G01 X ... Z... ;
Tool
Z
X
Workpiece
Fig.1.1 (b) Tool movement along the taper line
Program
G02X ... Z ... R ... ;
or
G03X ... Z ... R ... ;
Z
X
Tool
Workpiece
Fig. 1.1 (c) Tool movement along an arc
1.1
TOOL MOVEMENT
ALONG WORKPIECE
PARTS FIGURE–
INTERPOLATION
Explanations
D Tool movement along a
straight line
D Tool movement along an
arc

Leave a Reply

Your email address will not be published. Required fields are marked *