FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
17. PROGRAMMABLE PARAMETER
ENTRY (G10)
B–62754EN/01
326
G10L50; Parameter entry mode setting
N_R_; For parameters other than the axis type
N_P_R_; For axis type parameters
G11; Parameter entry mode cancel
N_: Parameter No. (4digits) or compensation position No.(0 to
1023) for
pitch errors compensation +10,000 (5digit)
R_: Parameter setting value (Leading zeros can be omitted.)
P_: Axis No. 1 to 8 (Used for entering axis type parameters)
Meaning of command
Format
Do not use a decimal point in a value set in a parameter (R_).
a decimal point cannot be used in a custom macro variable for R_ either.
Specify an axis number (P_) from 1 to 8 (up to eight axes) for an axis type
parameter. The control axes are numbered in the order in which they are
displayed on the CNC display.
For example, specify P2 for the control axis which is displayed second.
WARNING
1 Do not fail to perform reference point return manually after
changing the pitch error compensation data or backlash
compensation data. Without this, the machine position can
deviate from the correct position.
2 The canned–cycle mode must be cancelled before entering
of parameters. When not cancelled, the drilling motion will
be activated.
NOTE
Other NC statements cannot be specified while in
parameter input mode.
Format
Explanations
D Parameter setting value
(R_)
D Axis No.(P_)

Leave a Reply

Your email address will not be published. Required fields are marked *