FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

18. MEMORY OPERATION BY
FS15 TAPE FORMAT
B–62754EN/01
PROGRAMMING
328
18
MEMORY OPERATION BY FS15 TAPE FORMAT
Programs in the FS15 tape format can be registered in memory for
memory operation by setting bit 1 of parameter No. 0001. Registration
to memory and memory operation are possible for the functions which use
the same tape format as that for the FS15 as well as for the following
functions which use a different tape format:
Equal–lead threading
Subprogram calling
Canned cycle
Multiple repetitive canned cycle
Canned drilling cycle
NOTE
Registration to memory and memory operation are possible
only for the functions available in this CNC.

Leave a Reply

Your email address will not be published. Required fields are marked *