FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
18. MEMORY OPERATION BY
FS15 TAPE FORMAT
PROGRAMMING
329
Some addresses which cannot be used for the this CNC can be used in the
Series 15 tape format. The specifiable value range for the Series 15 tape
format is basically the same as that for the this CNC. Sections II–18.2 to
II–18.5 describe the addresses with a different specifiable value range.
If a value out of the specifiable value range is specified, an alarm is issued.
18.1
ADDRESSES AND
SPECIFIABLE VALUE
RANGE FOR Series
15 TAPE FORMAT

Leave a Reply

Your email address will not be published. Required fields are marked *