FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
1. GENERAL
15
Movement of the tool at a specified speed for cutting a workpiece is called
the feed.
Tool
Workpiece
Chuck
Fig. 1.2 (a) Feed function
Feedrates can be specified by using actual numerics.
For example, the following command can be used to feed the tool 2 mm
while the workpiece makes one turn :
F2.0
The function of deciding the feed rate is called the feed function (See
II–5).
1.2
FEED–
FEED FUNCTION

Leave a Reply

Your email address will not be published. Required fields are marked *