FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

18. MEMORY OPERATION BY
FS15 TAPE FORMAT
B–62754EN/01
PROGRAMMING
330
G32_F_Q_;
or
G32_E_Q_;
:Combination of axis addresses
F :Lead along the longitudinal axis
E :Lead along the longitudinal axis
Q :Sight of the threading start angle (ignored if specified)
Although the Series 15 allows the operator to specify the number of
threads per inch with address E, the Series 15 tape format does not.
Addresses E and F are used in the same way for specifying the lead along
the longitudinal axis. The thread lead specified with address E is therefore
also assumed as a continuous–state value for address F. Address Q for
specifying the shift of the threading start angle can be specified but is
ignored.
Address for thread lead mm input inch input
E
0.0001 to
500.0000mm
0.000001 to
9.999999inch
F
Command with a
decimal point
0.0001 to
500.0000mm
0.000001 to
9.999999inch
F
Command without a
decimal point
0.01 to 500.00mm 0.0001 to 9.9999inch
Address for feedrate mm input inch input
Feed
per
min te
Increment
system (IS–B)
1 to 240000
mm/min
0.01 to 9600.00
inch/min
F
m
i
nu
t
e
Increment
system (IS–C)
1 to 100000
mm/min
0.01 to 4800.00
inch/min
Feed per rotation 0.01 to 500.00
mm/rev
0.0001 to 9.9999
inch/rev
WARNING
Specify the feedrate one more time when switching
between feed per minute and feed per rotation.
18.2
EQUAL–LEAD
THREADING
Format
Explanations
D Address
D Specifiable value range
for the thread lead
D Specifiable value range
for the feedrate

Leave a Reply

Your email address will not be published. Required fields are marked *