FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
18. MEMORY OPERATION BY
FS15 TAPE FORMAT
PROGRAMMING
331
M98PffffLffff;
P:Subprogram number
L:Repetition count
Address L cannot be used in this CNC tape format but can be used in the
Series 15 tape format.
The specifiable value range is the same as that for this CNC (1 to 9999)
. If a value of more than four digits is specified, the last four digits are
assumed as the subprogram number.
The repetition count L can be specified in the range from 1 to 9999. If no
repetition count is specified, 1 is assumed.
18.3
SUBPROGRAM
CALLING
Format
Explanation
D Address
D Subprogram number
D Repetition count

Leave a Reply

Your email address will not be published. Required fields are marked *