FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

18. MEMORY OPERATION BY
FS15 TAPE FORMAT
B–62754EN/01
PROGRAMMING
332
End surface turning cycle (front taper cutting cycle)
G94X_Z_K_F_;
K:Length of the taper section along the Z–axis
Outer / inner surface turning cycle (straight cutting cycle)
G90X_Z_F_;
Outer / inner surface turning cycle (taper cutting cycle)
G90X_Z_I_F_;
I:Length of the taper section along the X–axis (radius)
Threading cycle (straight threading cycle)
G92X_Z_F_Q_;
F:Thread lead
Q:Shift of the threading start angle (ignored if specified)
Threading cycle (taper threading cycle)
G92X_Z_I_F_;
I:Length of the taper section along the X–axis (radius)
End surface turning cycle (front taper cutting cycle)
G94X_Z_F_;
Addresses I and K cannot be used for a canned cycle in this CNC tape
format but can be used in the Series 15 tape format. Address Q can be
specified in the Series 15 format but is ignored.
Same as that for equal–lead threading in section II–18.2. See section
II–18.2.
18.4
CANNED CYCLE
Format
D Address
D Specifiable value range
for the feedrate

Leave a Reply

Your email address will not be published. Required fields are marked *