FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
18. MEMORY OPERATION BY
FS15 TAPE FORMAT
PROGRAMMING
333
Multiple repetitive threading cycle
G76X_Z_I_K_D_F_A_P_Q_;
I : Difference of radiuses at threads
K : Height of thread crest (radius)
D : Depth of the first cut (radius)
A : Angle of the tool tip (angle of ridges)
P : Method of cutting
Outer / inner surface turning cycle
G71P_Q_U_W_I_K_D_F_S_T_;
I : Length and direction of cutting allowance for finishing the rough
machining cycle along the X–axis (ignored if specified)
K : Length and direction of cutting allowance for finishing the rough
machining cycle along the Z–axis (ignored if specified)
D : Depth of cut
End surface rough machining cycle
G72P_Q_U_W_I_K_D_F_S_T_;
I : Length and direction of cutting allowance for finishing the rough
machining cycle along the X–axis (ignored if specified)
K : Length and direction of cutting allowance for finishing the rough
machining cycle along the Z–axis (ignored if specified)
D : Depth of cut
Closed–loop turning cycle
G73P_Q_U_W_I_K_D_F_S_T_;
I : Length and direction of clearance along the X–axis (radius)
K : Length and direction of clearance along the Z–axis
D : Number of divisions
End surface cutting–off cycle
G74X_Z_I_K_F_D_;
or
G74U_W_I_K_F_D_;
I : Distance to be traveled along the X–axis
K : Depth of cut along the Z–axis
D : Clearance of the tool at the end of the cutting path
Outer / inner surface cutting–off cycle
G75X_Z_I_K_F_D_;
or
G75U_W_I_K_F_D_;
I : Distance to be traveled along the X–axis
K : Depth of cut along the Z–axis
D : Clearance of the tool at the end of the cutting path
18.5
MULTIPLE
REPETITIVE CANNED
TURNING CYCLE
Format

Leave a Reply

Your email address will not be published. Required fields are marked *