FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
18. MEMORY OPERATION BY
FS15 TAPE FORMAT
PROGRAMMING
335
Drilling cycle
G81X_C_Z_F_L_ ; or G82X_C_Z_R_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Peck drilling cycle
G81X_C_Z_R_Q_P_F_L_ ;
R : Distance from the initial level to the R position
Q : Depth of cut in each cycle
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
High–speed peck drilling cycle
G83.1X_C_Z_R_Q_P_F_L_ ;
R : Distance from the initial level to the R position
Q : Depth of cut in each cycle
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Tapping
G84X_C_Z_R_P_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Rigid tapping
G84.2X_C_Z_R_P_F_L_S_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
S : Spindle speed
Boring cycle
G85X_C_Z_R_F_L_ ; or G89X_C_Z_R_P_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Cancel
G80 ;
For this CNC tape format, the address used to specify the number of
repetitions is K. For the FS 15 tape format, it is L.
18.6
CANNED DRILLING
CYCLE FORMATS
Format
Explanations
D Address

Leave a Reply

Your email address will not be published. Required fields are marked *