FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
19. FUNCTIONS FOR HIGH SPEED
CUTTING
B–62754EN/01
342
During high–speed machining, the distribution processing status is
monitored. When distribution processing terminates, P/S alarm No. 000
and P/S alarm No. 179 are issued upon completion of the high–speed
machining command (according to the setting of ITPDL (bit 7 of
parameter No. 7501)).
These P/S alarms can be canceled only by turning off the CNC power.
High–speed machining using the high–speed remote buffer A function,
high–speed remote buffer B function, and high–speed cycle function
based on the G05 command
Failure to perform normal distribution processing because distribution
processing required for high–speed machining exceeded the CNC
processing capacity, or because distribution data sent from the host was
delayed for some reason while the high–speed remote buffer A or G
function was being used
Number Message Contents
000 PLEASE TURN OFF POWER
During high–speed machining,
distribution processing was ter-
minated.
Related parameters:
Remote buffer transfer baud rate
(
p
arameter No 133)
179 PARAM. (NO. 7510) SETTING
ERROR
( arameter
No
.
133)
Number of controlled axes in
high–speed machining (parame-
ter No. 7150)
High–speed axis selection dur-
ing high–speed machining (bit 0
of parameter No. 7510)
19.2
DISTRIBUTION
PROCESSING
TERMINATION
MONITORING
FUNCTION FOR THE
HIGH–SPEED
MACHINING
COMMAND (G05)
Explanations
D High–speed machining
command
D Distribution processing
termination

Leave a Reply

Your email address will not be published. Required fields are marked *