FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
20. AXIS CONTROL FUNCTION
PROGRAMMING
365
To replace the tool damaged during machining or to check the status of
machining, the tool can be withdrawn from a workpiece. The tool can
then be advanced again to restart machining efficiently.
The tool withdrawal and return operation consists of the following four
steps:
D Retract
The tool is retracted to a predefined position using the TOOL WITHDRAW
switch.
D Withdrawal
The tool is moved to the tool–change position manually.
D Return
The tool returns to the retract position.
DRepositioning
The tool returns to the interrupted position.
For the tool withdrawal and return operations, see Section 4.8 in
“Operation.”
X
Z
: Position where the TOOL WITHDRAW switch was turned on
: Programmed position
: Position to which the tool is retracted by manual operation
: Retraction path
: Manual operation (withdraw path)
: Return path
: Repositioning
Specify a retraction axis and distance in the following format:
G10.6 IP_;
IP_ : In incremental mode, retraction distance from the position
where the retract signal is turned on
In the absolute mode, retraction distance to an absolute
position
20.7
TOOL WITHDRAWAL
AND RETURN (G10.6)
Format

Leave a Reply

Your email address will not be published. Required fields are marked *