FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
21. TWO–PATH CONTROL
FUNCTION
377
Display and set tool shape data (interference forbidden areas) according
to the procedure below.
(1)Press function
OFFSET
SETTING
key.
(2)Press the chapter selection soft key
[TOOLFM].
(3)With the tool post selection signal, select a tool post for which
interference forbidden areas for tool post interference checking are to
be displayed and set.
(4)Display the screen including a tool number for which data is to be set.
Method 1:Select the screen by using the page keys and cursor keys.
Method 2:Enter a desired tool number, then press the soft key
[NO.SRH]
TOOL FORM DATA
O0001 N00001
OFFSET NO. = 01
AREA1
X = 20.000
Z = 70.000
I = –10.000
K = –50.000
OFFSET NO = 02
AREA1
X= 80.000
Z = 170.000
I = –100.000
K = –120.000
AREA 2
X = 40.000
Z = 70.000
I = 20.000
K = 30.000
AREA 2
X = –100.000
Z = –60.000
I = –140.000
K = –120.000
MEM
* * * *
* * * * * *
12 : 02 : 08 HEAD1
_
S 0 T0000
[ NO.SRH ][ ][ ][ +INPUT ][ INPUT ]
(5)Move the cursor to a data item to be set, with the cursor move keys.
(When data for point A is to be set, move the cursor to X and Z.
When data for point B is to be set, move the cursor to I and K.)
(6)With the numeric keys, enter the coordinates of point A or B.
(Fraction digits can be entered.)
X
Z
A (X, Z)
B (I, K)
X > I
Z > K
(7)By pressing the soft key [INPUT], the entered coordinates are set.
(Press the soft key
[+INPUT] when an entered numeric value is to set
after it is added to data already set.)
21.3.3
Setting and Display of
Interference Forbidden
Areas for Tool Post
Interference Checking
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *