FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
21. TWO–PATH CONTROL
FUNCTION
B–62754EN/01
382
The figures below show the setting of data for tool number 02 assigned
to tool post 1 and for tool number 15 assigned to tool post 2.
TOOL FORM DATA
O0001 N00001
OFFSET NO. = 01
AREA 1
X= 20.000
Z= 70.000
I= –10.000
K= –50.000
OFFSET NO. = 02
AREA 1
X= 80.000
Z= 170.000
I= –100.000
K= –120.000
AREA 2
X= 40.000
Z= 70.000
I= 20.000
K= 30.000
AREA 2
X= –100.000
Z= –60.000
J= –140.000
K= –120.000
MEM
* * * * * * * * * *
12:02:08 HEAD 1
_
S 0 T0000
[ NO.SRH ][ ][ ][ +INPUT ][ INPUT ]
TOOL FORM DATA
O0001 N00001
OFFSET NO. = 15
AREA 1
X= 115.000
Z= 170.000
I= –115.000
K= –115.000
OFFSET NO. = 16
AREA 1
X= 0.000
Z= 0.000
I= 0.000
K= 0.000
AREA 2
X= –75.000
Z= –115.000
I= –115.000
K= –215.000
AREA 2
X= 0.000
Z= 0.000
I= 0.000
K= 0.000
MEM
* * * * * * * * * *
12:02:36 HEAD 2
_
S 0 T0000
[ NO.SRH ][ ][ ][ +INPUT ][ INPUT ]
Set data for other tools similarly. A preparation for an interference check
is completed when data has been set for all tools. Turn on power. Then,
an interference check is started when a T code is specified with each tool
post
after reference point return operation is completed with all of the four axes
(X1, Z1, X2, Z2).

Leave a Reply

Your email address will not be published. Required fields are marked *