FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
21. TWO–PATH CONTROL
FUNCTION
389
Exchanges the move commands for different axes of different systems.
Example)
Exchanging the commands for the X1 and X2 axes
–> Upon the execution of a command programmed for system 1,
movement is performed along the X2 and Z1 axes.
Upon the execution of a command programmed for system 2,
movement is performed along the X1 and Z2 axes.
Machining according to a
program for system 1
Machining accord-
ing to a program for
system 2
Workpiece 1
Turret 1
Work-
piece 2
Turret 2
Z1
X2
Z2
X1
Provides a move command of an axis for a different axis in another
system.
Example)
Providing the Z2 axis with a move command specified for the Z1
axis
Workpiece 1
Turret 1
Work-
piece 2
Turret 2Z1
X2
Z2
X1
Machining according
to a program for sys-
tem 1
Machining according to a program
for system 2
D Composite control
D Superposition control

Leave a Reply

Your email address will not be published. Required fields are marked *