FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
1. GENERAL
B–62754EN/01
412
When the cycle start push button is pressed, the tool executes one
operation then stops. By pressing the cycle start again, the tool executes
the next operation then stops. The program is checked in this manner.
Cycle start
Cycle start
Cycle start
Cycle start
Tool
Workpiece
Fig.1.4 (c) Single Block
Tool
CRT/MDI
X
Z
The tool remains stopped, and only the
positional displays of the axes change.
Workpiece
Fig1.4 (d) Machine Lock
When automatic running is placed into the auxiliary function lock mode
during the machine lock mode, all auxiliary functions (spindle rotation,
tool replacement, coolant on/off, etc.) are disabled.
D Single block (See
Section III–5.5)
1.4.2
How to View the
Position Display
Change without
Running the Machine
Explanations
D Machine lock (See
Sections III–5.1)
D Auxiliary function lock
(See Section III–5.1)

Leave a Reply

Your email address will not be published. Required fields are marked *