FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
1. GENERAL
415
Offset value of the toolOffset value of the tool
Workpiece
Tool
Fig.1.6 (c) Offset Value
Apart from parameters, there is data that is set by the operator in
operation. This data causes machine characteristics to change.
For example, the following data can be set:
Inch/Metric switching
I/O devices selection
Mirror image cutting on/off
The above data is called setting data (See Section III–11.4.3).
Setting
DisplayingScreen Keys
Setting data
Inch/Metric switching
I/O device selection
Mirror image ON/OFF setting
CNC Memory
Program
Automatic
operation
Operational
characteristics
Movement of
the machine
Fig.1.6 (d) Displaying and Setting Operators setting data
D Displaying and setting
operators setting data

Leave a Reply

Your email address will not be published. Required fields are marked *