FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
2. OPERATIONAL DEVICES
439
Table2.2 Explanation of the MDI keyboard
Number ExplanationName
10 Function keys
POS PROG
Press theses keys to switch display screens for each function.
See sec. 2.3 for details of the function keys.
11 Cursor move keys There are four different cursor move keys.
: This key is used to move the cursor to the right or in the forward
direction. The cursor is moved in short units in the forward direction.
: This key is used to move the cursor to the left or in the reverse
direction. The cursor is moved in short units in the reverse direction.
: This key is used to move the cursor in a downward or forward
direction. The cursor is moved in large units in the forward direction.
: This key is used to move the cursor in an upward or reverse direction.
The cursor is moved in large units in the reverse direction.
12 Page change keys
PAGE
PAGE
Two kinds of page change keys are described below.
: This key is used to changeover the page on the CRT screen in the
forward direction.
: This key is used to changeover the page on the CRT screen in the
reverse direction.
PAGE
PAGE

Leave a Reply

Your email address will not be published. Required fields are marked *