FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
2. OPERATIONAL DEVICES
B–62754EN/01
468
B1B1 – 01
SLOT 01 (3046) : END
SLOT 02 (3050) :
Blank: Setting not com-
pleted
Module ID
Slot number
END: Setting completed
B1B1 – 01
CNC control software
SERVO : 9070–01
SUB : xxxx–xx
OMM : yyyy–yy
PMC : zzzz–zz
Digital servo ROM
Sub CPU (remote buffer)
Order–made macro/macro
compiler
PMC
Procedure for Poser Disconnection
1 Check that the LED indicating the cycle start is off on the operators
panel.
2 Check that all movable parts of the CNC machine tool is stopping.
3 If an external input/output device such as the Handy File is connected
to the CNC, turn off the external input/output device.
4 Continue to press the POWER OFF pushbutton for about 5 seconds.
5 Refer to the machine tool builders manual for turning off the power
to the machine.
Screen indicating
module setting status
Display of software
configuration
2.5.3
Power Disconnection

Leave a Reply

Your email address will not be published. Required fields are marked *