FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
3.MANUAL OPERATION
B–62754EN/01
472
In the JOG mode, pressing a feed axis and direction selection switch on
the machine operators panel continuously moves the tool along the
selected axis in the selected direction.
The manual continuous feedrate is specified in a parameter (No.1423)
The manual continuous feedrate can be adjusted with the manual
continuous feedrate override dial.
Pressing the rapid traverse switch moves the tool at the rapid traverse
feedrate (No.1424) regardless of the position of the JOG feedrate override
dial. This function is called the manual rapid traverse.
Manual operation is allowed for one axis at a time. 3 axes can be selected
at a time by parameter JAX (No.1002#0).
While a switch is pressed, the
tool moves in the direction
specified by the switch.
φD
Tool
v m/min
N rpm
Workpiece
Y
X
Z
Procedure for JOG Feed
1 Press the manual continuous switch, one of the mode selection
switches.
2 Press the feed axis and direction selection switch corresponding to the
axis and direction the tool is to be moved. While the switch is pressed,
the tool moves at the feedrate specified in a parameter (No. 1423).
The tool stops when the switch is released.
3 The manual continuous feedrate can be adjusted with the manual
continuous feedrate override dial.
4 Pressing the rapid traverse switch while pressing a feed axis and
direction selection switch moves the tool at the rapid traverse rate
while the rapid traverse switch is pressed. Rapid traverse override by
the rapid traverse override switches is effective during rapid traverse.
The above is an example. Refer to the appropriate manual provided
by the machine tool builder for the actual operations.
3.2
JOG FEED
REMOTE
MDI
MEMORY
EDIT
ZERO
RETURN
TEACH
JOG
HANDLE
MODE
+C +X +Y
+Z–Z
–C–y –X
rapid
AXIS DIRECTION
0 2000
JOG FEED RATE OVERRIDE
50
100
25
F0
RAPID TRAVERSE
OVERRIDE (%)

Leave a Reply

Your email address will not be published. Required fields are marked *