FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
3.MANUAL OPERATION
B–62754EN/01
484
For jog feed
The feedrate can be overridden using the manual feedrate override
dial.
The procedure above is just an example. For actual operations, refer
to the relevant manual provided by the machine tool builder.
For feed along an axis, no straight line/circle definition is required. For
linear feed or circular feed, a straight line or circle must be defined
beforehand. (For circular feed, for example, data such as a radius and the
center of a circle must be set.) For details, refer to the relevant manual
provided by the machine tool builder.
In manual handle feed, the tool can be moved along a specified axis
(X–axis, Y–axis, Z–axis, ..., or the 8th axis), or can be moved along a
tilted straight line (linear feed) or a circle (circular feed).
(1)Feed along a specified axis (simultaneous 1–axis control)
By turning a manual handle, the tool can be moved along the desired
axis (such as X–axis, Y–axis, and Z–axis) on a simultaneous 1–axis
control basis. (This mode of feed is the conventional type of manual
handle feed.)
X
Y
Path of travel using the Y–axis handle
Path of travel using the X–axis handle
Feed along a specified axis
Explanations
D Definition of a straight
line/circle
D Manual handle feed

Leave a Reply

Your email address will not be published. Required fields are marked *