FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
3. MANUAL OPERATION
487
Even in JOG mode, manual handle feed can be enabled using bit 0 (JHD)
of parameter No. 7100. In this case, however, manual handle feed is
enabled only when the tool is not moved along any axis by jog feed.
Never use the mirror image function when performing manual operation.
(Perform manual operation when the mirror image switch is off, and
mirror image setting is off.)
D Manual handle feed in
JOG mode
Limitations
D Mirror image

Leave a Reply

Your email address will not be published. Required fields are marked *