FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
4. AUTOMATIC OPERATION
493
5 To execute a program, set the cursor on the head of the program. (Start
from an intermediate point is possible.) Push Cycle Start button on
the operators panel. By this action, the prepared program will start.
(For the two–path control, select the tool post to be operated with the
tool post selection switch on the machine operators panel
beforehand.)
When the program end (M02, M30) or ER(%) is executed, the
prepared program will be automatically erased and the operation will
end.
By command of M99, control returns to the head of the prepared
program.
O0001 N00003
MDI
**** *** ***
12 : 42 : 39
PRGRM
CURRNT
NEXT (OPRT)
PROGRAM ( MDI )
G00 X100.0 Z200.;
M03 ;
G01 Z120.0 F500 ;
M93 P9010 ;
G00 Z0.0 ;
%
G00 G90 G94 G40 G80 G50 G54 G69
G17 G22 G21 G49 G98 G67 G64 G15
BHM
TD
FS
>_
O0000
MDI
6 To stop or terminate MDI operation in midway through, follow the
steps below.
a.
Stopping MDI operation
Press the feed hold switch on the machine operators panel. The
feed hold LED goes on and the cycle start LED goes off. The
machine responds as follows:
(i) When the machine was moving, feed operation decelerates
and stops.
(ii) When dwell was being performed, dwell is stopped.
(iii) When M, S, or T was being executed, the operation is
stopped after M, S, or T is finished.
When the cycle start switch on the machine operators panel
is pressed, machine operation restarts.
b. Terminating MDI operation
Press the
RESET
key on the CRT/MDI (or LCD/MDI) panel.
Automatic operation is terminated and the reset state is entered.
When a reset is applied during movement, movement
decelerates then stops.

Leave a Reply

Your email address will not be published. Required fields are marked *