FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
4. AUTOMATIC OPERATION
499
Procedure for Program Restart by Specifying a Block Number
1 Retract the tool and replace it with a new one. When necessary,
change the offset. (Go to step 2.)
1 When power is turned ON or emergency stop is released, perform all
necessary operations at that time, including the reference position
return.
2 Move the machine manually to the program starting point (machining
start point), and keep the modal data and coordinate system in the
same conditions as at the machining start.
3 If necessary, modify the offset amount.
1 Turn the program restart switch on the machine operator’s panel ON.
2 Press function
PROG
key to display the desired program.
3 Find the program head. Press function
RESET
key.
4 Enter the number of the block to be restarted then press the
[P TYPE]
or [Q TYPE]
soft key. The block number cannot exceed eight digits.
5 The block number is searched for, and the program restart screen
appears on the CRT display.
PROGRAM RESTART
DESTINATION
X 57. 096
Z 56. 943
DISTANCE TO GO
X 1. 459
Z 7. 320
M1 2
12
12
12
12
1********
******** ********
T******** ********
S *****
O0002 N01000
S 0 T0000
MEM
**** *** ***
10 : 10 : 40
FL.SDL
(OPRT)
RSTR
DESTINATION shows the position at which machining is to restart.
DISTANCE TO GO shows the distance from the current tool position
to the position where machining is to restart. A number to the left of
each axis name indicates the order of axes (determined by parameter
setting) along which the tool moves to the restart position.
Procedure 1
[ P TYPE ]
[ Q TYPE ]
Procedure 2
[COMMON TO P TYPE /
Q TYPE]
N
f f f f f f f f
Block number
[P TYPE]
or
[Q TYPE]

Leave a Reply

Your email address will not be published. Required fields are marked *