FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
4. AUTOMATIC OPERATION
507
O0000 N02000
RMT
**** *** ***
10 : 10 : 40
FILE DIRECTORY
ORDER FILE NO. REQ.REP CUR.REP
01 0007 5 5
02 0003 23 23
03 0004 9999 156
04 0005 LOOP 0
05
06
07
08
09
10
PRGRM
(OPRT)
DIR
Screen No.5
SCHDUL
If no file number is specified on screen No. 4 (the file number field is left
blank), program execution is stopped at that point. To leave the file
number field blank, press numeric key
0
then
INPUT
.
If a negative value is set as the number of repetitions,
<LOOP> is
displayed, and the file is repeated indefinitely.
When the [(OPRT)], [CLEAR], and [EXEC] soft keys are pressed on
screen No. 4, all data is cleared. However, these keys do not function
while a file is being executed.
When the
[PRGRM] soft key is pressed on screen No. 1, 2, 3, 4, or 5, the
program screen is displayed.
Up to 9999 can be specified as the number of repetitions. If 0 is set for a
file, the file becomes invalid and is not executed.
By pressing the page key on screen No. 4, up to 20 files can be registered.
When M codes other than M02 and M30 are executed in a program, the
current number of repetitions is not increased.
During the execution of file, the floppy directory display of background
editing cannot be referenced.
To resume automatic operation after it is suspended for scheduled
operation, press the reset button.
The scheduling function can be used only for a single tool post.
Explanations
D Specifying no file
number
D Endless repetition
D Clear
D Return to the program
screen
Limitation
D Number of repetitions
D Number of files
registered
D M code
D Displaying the floppy
disk directory during file
execution
D Restarting automatic
operation
D Scheduling function for
the two–path control

Leave a Reply

Your email address will not be published. Required fields are marked *