FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
4. AUTOMATIC OPERATION
B–62754EN/01
512
The following table indicates the relation between other functions and the
movement by handle interrupt.
Display Relation
Machine lock
Machine lock is effective. The tool does not move
even when this signal turns on.
Interlock
Interlock is effective. The tool does not move
even when this signal turns on.
Mirror image
Mirror image is not effective. Interrupt functions on
the plus direction by plus direction command,
even if this signal turns on.
The following table shows the relation between various position display
data and the movement by handle interrupt.
Display Relation
Absolute coordinate
value
Handle interruption does not change absolute
coordinates.
Relative coordinate
value
Handle interruption does not change relative
coordinates.
Machine coordinate
value
Machine coordinates are changed by the travel
distance specified by handle interruption.
Press the function key
POS
, then press the chapter selection soft key
[HNDL].
The move amount by the handle interrupt is displayed. The following 4
kinds of data are displayed concurrently.
O0000 N00200
MDI
**** *** ***
10 : 29 : 51
HANDLE INTERRUPTION
(INPUT UNIT)
(OUTPUT UNIT)
X 69.594 X 69.594
Z –61.439 Z –61.439
(RELATIVE)
U 0.000 X 0.000
W0.000 Z 0.000
(DISTANCE TO GO)
PART COUNT 287
RUN TIME 1H 12M CYCLE TIME 0H 0M 0S
ABS
REL ALL (OPRT)
HNDL
(a) INPUT UNIT :
Handle interrupt move amount in input unit system
Indicates the travel distance specified by handle interruption
according to the least input increment.
(b) OUTPUT UNIT :
Handle interrupt move amount in output unit
system
Indicates the travel distance specified by handlei nterruption
according to the least command increment.
Explanations
D Relation with other
functions
D Position display
D Travel distance display

Leave a Reply

Your email address will not be published. Required fields are marked *