FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
4. AUTOMATIC OPERATION
B–62754EN/01
520
Number Message Contents
086 DR SIGNAL OFF When entering data in the memory by
using Reader / Puncher interface, the
ready signal (DR) of reader / puncher
was turned off.
Power supply of I/O unit is off or cable is
not connected or a P.C.B. is defective.
123 CAN NOT USE MACRO
COMMAND IN DNC
Macro control command is used during
DNC operation.
Modify the program.
210 CAN NOT COMAND
M198/M199
Or M198 is executed in the DNC opera-
tion. Modify the program.
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *