FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
5. TEST OPERATION
529
lG73
(Closed–loop cutting cycle)
Rapid traverse
Cutting feed
S
: Single–block stop
Tool path 1
to 6 is as-
sumed as
one cycle.
After 10 is
finished, a
stop is
made.
lG74
(End surface cutting–off cycle)
G75
(Outer/inner surface cutting–off
cycle)
1
2
3
4
5
6
7
8
9
10
This figure shows the case for G74. G75 is the same.
S
1
2
3
4
5
6
1
2
3
4
S
lG76
(Multiple repetitive threading cycle)
Tool path 1
to 4 is as-
sume as
one cycle.
After 4 is fin-
ished, a stop
is made.
S
Tool path 1
to 10 is as-
sumed as
one cycle.
After 10 is
finished, a
stop is
made.
Tool path
Explanation
Fig. 5.5(b) Single block during canned cycle (2/2)
Single block stop is not performed in a block containing M98P_;. M99;
or G65.
However, single block stop is even performed in a block with M98P_ or
M99 command, if the block contains an address other than O, N or P.
D Subprogram call and
single block

Leave a Reply

Your email address will not be published. Required fields are marked *