FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
6. SAFETY FUNCTIONS
OPERATION
547
In cylindrical interpolation mode, no check is made.
In polar coordinate interpolation mode, no check is made.
When the slanted axis control option is selected, no check is made.
In simple synchronous control, only the master axis is checked; no slave
axes are checked.
During drawing, no check is made.
No check is made for a movement based on PMC axis control.
No check is made for a chuck/tailstock barrier area (lathe system).
No check is made for an axis placed in synchronous mixed mode
(two–path lathe control).
Number Message Contents
506 OVER TRAVEL :
+n
The stroke limit check, made before move-
ments is performed, reveals that the tool
would enter a inhibited area in the + direction.
507 OVER TRAVEL :
–n
The stroke limit check, made before move-
ments is performed, reveals that the tool
would enter a inhibited area in the – direction.
D Cyrindrical interpolation
mode
D Polar coordinate
interpolation mode
D Slanted axis control
D Simple synchronous
control
D Drawing
D PMC axis control
D Chuck/tailstock barrier
D Synchronous mixed
mode
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *