FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
7. ALARM AND SELF–DIAGNOSIS
FUNCTIONS
B–62754EN/01
552
The system may sometimes seem to be at a halt, although no alarm has
occurred. In this case, the system may be performing some processing.
The state of the system can be checked by displaying the self–diagnostic
screen.
Procedure for Diagnostic
1 Press the function key
SYSTEM
.
2 Press the chapter select key
[DGNOS].
3 The diagnostic screen has more than 1 pages. Select the screen by the
following operation.
(1)Change the page by page key
PAGE
or
PAGE
.
(2)Method by soft key
– Key input the number of the diagnostic data to be displayed.
– Press
[N SRCH].
DGNOS
DIAGNOSTIC (GENERAL) O0000 N00000
EDIT
**** *** ***
14 : 51 : 55
000 WAITING FOR FIN SIGNAL :0
001 MOTION :0
002 DWELL :0
003 IN–POSITION CHECK :0
004 FEEDRATE OVERRIDE 0% :0
005 INTERLOCK/START–LOCK :0
006 SPINDLE SPEED ARRIVAL CHECK :0
PARAM PMC
SYSTEM
(OPRT)
)_
For the two–path control, the diagnostic screen for the tool post selected
with the tool post selection switch is displayed. When displaying the
diagnostic screen for the other tool post, specify the tool post with the tool
post selection switch.
7.3
CHECKING BY
SELF–DIAGNOSTIC
SCREEN
Explanations
D Self diagnostic screen at
2–path control

Leave a Reply

Your email address will not be published. Required fields are marked *