FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

8. DATA INPUT/OUTPUT
B–62754EN/01
OPERATION
558
When the program is input from the floppy, the file to be input first
must be searched.
For this purpose, proceed as follows:
File 1
File searching of the file n
File n
BlankFile 2 File 3
Procedure for File Heading
1 Press the EDIT or MEMORY switch on the machine operators
panel.
2 Press function key
PROG
, then the program contents display screen or
program check screen appears.
3 Press soft key [(OPRT)]
4 Press the rightmost soft key (next–menu key).
5 Enter address N.
6 Enter the number of the file to search for.
N0
The beginning of the cassette or card is searched.
One of N1 to N9999
Of the file Nos. 1 to 9999, a designated file is searched.
N–9999
The file next to that accessed just before is searched.
N–9998
When N–9998 is designated, N–9999 is automatically inserted
each time a file is input or output. This condition is reset by the
designation of N1,N1 to 9999, or N9999 or reset.
7 Press soft keys
[FSRH] and [EXEC]
The specified file is searched for.
The same result is obtained both by sequentially searching the files by
specifying Nos. N1 to N9999 and by first searching one of N1 to N9999
and then using the N–9999 searching method. The searching time is
shorter in the latter case.
8.2
FILE SEARCH
Explanations
D File search by N–9999

Leave a Reply

Your email address will not be published. Required fields are marked *