FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
8. DATA INPUT/OUTPUT
OPERATION
559
No. Description
86
The ready signal (DR) of an input/output device is off.
An alarm is not immediately indicated in the CNC even when
an alarm occurs during head searching (when a file is not
found, or the like).
An alarm is given when the input/output operation is performed
after that. This alarm is also raised when N1 is specified for
writing data to an empty floppy. (In this case, specify N0.)
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *