FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
8. DATA INPUT/OUTPUT
OPERATION
563
S Pressing the [CHAIN] soft key positions the cursor to the end of the
registered program. Once a program has been input, the cursor is
positioned to the start of the new program.
S Additional input is possible only when a program has already been
registered.
If an attempt has been made to register a program having the same number
as that of a previously registered program, P/S alarm 073 is issued and the
program cannot be registered.
No. Description
70 The size of memory is not sufficient to store the input programs
73
An attempt was made to store a program with an existing pro-
gram number.
79
The verification operation found a mismatch between a pro-
gram loaded into memory and the contents of the program on
the floppy or NC tape.
D Defining the same
program number as that
of an existing program
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *