FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

8. DATA INPUT/OUTPUT
B–62754EN/01
OPERATION
566
Offset data is loaded into the memory of the CNC from a floppy or NC
tape. The input format is the same as for offset value output. See section
III–8.5.2. When an offset value is loaded which has the same offset
number as an offset number already registered in the memory, the loaded
offset data replaces existing data.
Procedure for Inputting Offset Data
1 Make sure the input device is ready for reading
For the two–path control, select the tool post for which offset data to
be input is used with the tool post selection switch.
2 Press the EDIT switch on the machine operators panel.
3 When using a floppy, search for the required file according to the
procedure in Section III–8.2.
4 Press function key
OFFSET
SETTING
to display tool offset screeen.
5 Press soft keys
[(OPRT)], then the tool compensation screen appears.
6 Press rightmost soft key
(next menu key).
7 Press soft keys
[READ] and [EXEC].
8 The input offset data will be displayed on the screen after completion
of input operation.
8.5
OFFSET DATA INPUT
AND OUTPUT
8.5.1
Inputting Offset Data

Leave a Reply

Your email address will not be published. Required fields are marked *