FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

8. DATA INPUT/OUTPUT
B–62754EN/01
OPERATION
568
Parameters and pitch error compensation data are input and output from
different screens, respectively. This chapter describes how to enter them.
Parameters are loaded into the memory of the CNC unit from a floppy or
NC tape. The input format is the same as the output format. See Subsec.
III–8.6.2. When a parameter is loaded which has the same data number
as a parameter already registered in the memory, the loaded parameter
replaces the existing parameter.
Procedure for Inputting Parameters
1 Make sure the input device is ready for reading.
For the two–path control, select the tool post for which parameters to
be input are used with the tool post selection switch.
2 When using a floppy, search for the required file according to the
procedure in Section
III–8.2.
3 Press the EMERGENCY STOP button on the machine operators
panel.
4 Press function key
OFFSET
SETTING
.
5 Press the soft key
[SETING] for chapter selection, then the setting
screen appears.
6 Enter 1 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data. P/S alarm (No.100(indicating that parameters
can be written)) appears.
7 Press soft key
SYSTEM
.
8 Press chapter selection soft key
[PARAM], then the parameter screen
appears.
9 Press soft key
[(OPRT)].
10 Press the rightmost soft key
(next–menu key).
11 Press soft keys
[READ] and [EXEC].
Parameters are read into memory. Upon completion of input, the
“INPUT” indicator at the lower–right corner of the screen disappears.
12 Press function key
OFFSET
SETTING
.
13 Press soft key
[SETING] for chapter selection.
8.6
INPUTTING AND
OUTPUTTING
PARAMETERS AND
PITCH ERROR
COMPENSATION
DATA
8.6.1
Inputting Parameters

Leave a Reply

Your email address will not be published. Required fields are marked *