FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
8. DATA INPUT/OUTPUT
OPERATION
571
14 Enter 0 in response to the prompt for “PARAMETER WRITE
(PWE)” of setting data.
15 Turn the power to the NC back on.
16 Release the EMERGENCY STOP button on the machine operators
panel.
Parameters 3620 to 3624 and pitch error compensation data must be set
correctly to apply pitch error compensation correctly
(See subsec.
III–11.5.2)
All pitch error compensation data are output in the defined format from
the memory of the CNC to a floppy or NC tape.
Procedure for Outputting Pitch Error Compensation Data
1 Make sure the output device is ready for output.
For the two–path control, select the tool post for which pitch error
compensation data to be output is used with the tool post selection
switch.
2 Specify the punch code system (ISO or EIA) using a parameter.
3 Press the EDIT switch on the machine operators panel.
4 Press function key
SYSTEM
.
5 Press the rightmost soft key
(next–menu key) and press chapter
selection soft key
[PITCH].
6 Press soft key
[(OPRT)].
7 Press rightmost soft key
(next–menu key).
8 Press soft keys [PUNCH] and [EXEC].
All pitch error compensation data are output in the defined format.
Output format is as follows:
N 10000 P ;
N 11023 P ;
N:Pitch error compensation point No. +10000
P:Pitch error compensation data
When the floppy disk directory display function is used, the name of the
output file is “
PITCH ERROR”.
Explanations
D Pitch error
compensation
8.6.4
Outputting Pitch Error
Compensation Data
Explanations
D Output format
D Output file name

Leave a Reply

Your email address will not be published. Required fields are marked *