FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

8. DATA INPUT/OUTPUT
B–62754EN/01
OPERATION
578
The contents of the specified file number are read to the memory of NC.
Procedure for Reading Files
1 Press the EDIT switch on the machine operators panel.
For the two–path control, select the tool post for which a file is to be
input in memory with the tool post selection switch.
2 Press function key
PROG
.
3 Press the rightmost soft key
(next–menu key).
4 Press soft key [FLOPPY].
5 Press soft key
[(OPRT)].
6 Press soft key
[READ].
**** *** ***
11 : 55 : 04
READ
FILE NO. =
>_
EDIT
O0001 N00000
(METER) VOL
DIRECTORY (FLOPPY)
NO. FILE NAME
CAN
F SET
EXEC
PROGRAM NO. =
O SET
STOP
7 Enter a file number.
8 Press soft key
[F SET].
9 To modify the program number, enter the program number, then press
soft key
[O SET].
10 Press soft key
[EXEC]. The file number indicated in the lower–left
corner of the screen is automatically incremented by one.
11 Press soft key
[CAN] to return to the soft key display shown in the
screen of Fig.
8.8.1.(b).
8.8.2
Reading Files

Leave a Reply

Your email address will not be published. Required fields are marked *