FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
8. DATA INPUT/OUTPUT
OPERATION
579
Any program in the memory of the CNC unit can be output to a floppy
as a file.
Procedure for Outputting Programs
1 Press the EDIT switch on the machine operators panel.
For the two–path control, select the tool post for which a program is to
be output from floppy with the tool post selection switch.
2 Press function key
PROG
.
3 Press the rightmost soft key
(next–menu key).
4 Press soft key [FLOPPY].
5 Press soft key [(OPRT)].
6 Press soft key [PUNCH]
EDIT
**** *** ***
11 : 55 : 26
PUNCH
FILE NO. =
>_
O0002 N01000
(METER) VOL
DIRECTORY (FLOPPY)
NO. FILE NAME
CAN
F SET
EXEC
PROGRAM NO. =
O SET
STOP
7 Enter a program number. To write all programs into a single file, enter
–9999 in the program number field. In this case, the file name
“ALL.PROGRAM” is registered.
8 Press soft key
[O SET].
9 Press soft key
[EXEC]. The program or programs specified in step 7
are written after the last file on the floppy. To output the program after
deleting files starting with an existing file number, key in the file
number, then press soft key
[F SET] followed by soft key [EXEC].
10 Press soft key
[CAN] to return to the soft key display shown in the
screen of Fig.8.8.1(b).
8.8.3
Outputting Programs

Leave a Reply

Your email address will not be published. Required fields are marked *