FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
9. EDITING PROGRAMS
OPERATION
587
The cursor can be jumped to the top of a program. This function is called
heading the program pointer. This section describes the three methods
for heading the program pointer.
Procedure for Heading a Program
1 Press
RESET
when the program screen is selected in EDIT mode.
When the cursor has returned to the start of the program, the contents
of the program are displayed from its start on the screen.
Search for the program number.
1 Press address
O
,when a program screen is selected in the
MEMORY or EDIT mode.
2 Input a program number.
3 Press the soft key
[O SRH].
1 Select
MEMORY or EDIT mode.
2 Press
PROG
.
3 Press the
[(OPRT)] key.
4 Press the
[REWIND] key.
9.1.2
Heading a Program
Method 1
Method 2
Method 3

Leave a Reply

Your email address will not be published. Required fields are marked *