FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

B–62754EN/01
9. EDITING PROGRAMS
OPERATION
593
When memory holds multiple programs, a program can be searched for.
There are three methods as follows.
Procedure for program number search
1 Select EDIT or MEMORY mode.
2 Press
PROG
to display the program screen.
3 Key in address
O
.
4 Key in a program number to be searched for.
5 Press the
[O SRH] key.
6 Upon completion of search operation, the program number searched
for is displayed in the upper–right corner of the CRT screen.
If the program is not found , P/S alarm No. 71 occurs.
1 Select
EDIT or MEMORY mode.
2 Press
PROG
to display the program screen.
3 Press the
[O SRH] key.
In this case, the next program in the directory is searched for .
This method searches for the program number (0001 to 0015)
corresponding to a signal on the machine tool side to start automatic
operation. Refer to the relevant manual prepared by the machine tool
builder for detailed information on operation.
1 Select
MEMORY mode.
2 Set the reset state(*1)
The reset state is the state where the LED for indicating that
automatic operation is in progress is off. (Refer to the relevant
manual of the machine tool builder.)
3 Set the program number selection signal on the machine tool side to a
number from 01 to 15.
If the program corresponding to a signal on the machine tool side is
not registered, P/S alarm (No. 059) is raised.
4 Press the cycle start button.
When the signal on the machine tool side represents 00, program
number search operation is not performed.
Alarm No. Contents
59 The program with the selected number cannot be searched
during external program number search.
71 The specified program number was not found during
program number search.
9.3
PROGRAM NUMBER
SEARCH
Method 1
Method 2
Method 3
Alarm

Leave a Reply

Your email address will not be published. Required fields are marked *