FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

9. EDITING PROGRAMS
B–62754EN/01
OPERATION
602
Another program can be inserted at an arbitrary position in the current
program.
Oxxxx
Before merge
B
Oyyyy
Merge
Fig. 9.6.4 Merging a program at a specified location
A
Oxxxx
After merge
B
Oyyyy
B
A
C
C
Merge
location
In Fig. 9.6.4, the program with program number XXXX is merged with the
program with program number YYYY. The OYYYY program remains
unchanged after merge operation.
Procedure for merging a program
1 Perform steps 1 to 5 in subsection III–9.6.1.
2 Check that the screen for the program to be edited is selected and press
soft key
[MERGE].
3 Move the cursor to the position at which another program is to be
inserted and press soft key
[’CRSR] or [BTTM’](in the latter case,
the end of the current program is displayed).
4 Enter the number of the program to be inserted (with only numeric
keys) and press the
INPUT
key.
5 Press soft key
[EXEC].
The program with the number specified in step 4 is inserted before the
cursor positioned in step 3.
9.6.4
Merging a Program
EXEC
0 9
to
’CRSR BTTM’
MERGE
Numeric keys

Leave a Reply

Your email address will not be published. Required fields are marked *