FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
10. CREATING PROGRAMS
611
10
CREATING PROGRAMS
Programs can be created using any of the following methods:
MDI keyboard
PROGRAMMING IN TEACH IN MODE
CONVERSATIONAL PROGRAMMING INPUT WITH GRAPHIC
FUNCTION
CONVERSATIONAL AUTOMATIC PROGRAMMING FUNCTION
AUTOMATIC PROGRAM PREPARATION DEVICE (FANUC
SYSTEM P)
This chapter describes creating programs using the MDI panel, TEACH
IN mode, and conversational programming with graphic function. This
chapter also describes the automatic insertion of sequence numbers.

Leave a Reply

Your email address will not be published. Required fields are marked *