FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
10. CREATING PROGRAMS
B–62754EN/01
612
Programs can be created in the EDIT mode using the program editing
functions described in Chapter III–9.
Procedure for Creating Programs Using the MDI Panel
1 Enter the EDIT mode.
2 Press the
PROG
key.
3 Press address key
O
and enter the program number.
4 Press the
INSERT
key.
5 Create a program using the program editing functions described in
Chapter 9.
Comments can be written in a program using the control in/out codes.
Example)O0001 (FANUC SERIES 16) ;
M08 (COOLANT ON) ;
D When the
INSERT
key is pressed after the control–out code “(”,
comments, and control–in code “)” have been typed, the typed
comments are registered.
D When the
INSERT
key is pressed midway through comments, to enter the
rest of comments later, the data typed before the
INSERT
key is pressed
may not be correctly registered (not entered, modified, or lost) because
the data is subject to an entry check which is performed in normal
editing.
Note the following to enter a comment:
D Control–in code “)” cannot be registered by itself.
D Comments entered after the
INSERT
key is pressed must not begin with
a number, space, or address O.
D If an abbreviation for a macro is entered, the abbreviation is converted
into a macro word and registered (see Section 9.7).
D Address O and subsequent numbers, or a space can be entered but are
omitted when registered.
10.1
CREATING
PROGRAMS USING
THE MDI PANEL
Procedure
Explanation
D Comments in a program

Leave a Reply

Your email address will not be published. Required fields are marked *