FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
10. CREATING PROGRAMS
613
Sequence numbers can be automatically inserted in each block when a
program is created using the MDI keys in the EDIT mode.
Set the increment for sequence numbers in parameter 3216.
Procedure for automatic insertion of sequence numbers
1 Set 1 for SEQUENCE NO. (see subsection III–11.4.3).
2 Enter the
EDIT mode.
3 Press
PROG
to display the program screen.
4 Search for or register the number of a program to be edited and move
the cursor to the EOB (;) of the block after which automatic insertion
of sequence numbers is started.
When a program number is registered and an
EOB (;) is entered with
the
INSERT
key, sequence numbers are automatically inserted starting
with 0. Change the initial value, if required, according to step 10, then
skip to step 7.
5 Press address key
N
and enter the initial value of N.
6 Press
INSERT
key.
7 Enter each word of a block.
8 Press
EOB
key.
10.2
AUTOMATIC
INSERTION OF
SEQUENCE
NUMBERS
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *