FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
10. CREATING PROGRAMS
B–62754EN/01
614
9 Press
INSERT
. The EOB is registered in memory and sequence numbers
are automatically inserted. For example, if the initial value of
N is 10
and the parameter for the increment is set to 2, N12 inserted and
displayed below the line where a new block is specified.
EDIT
**** *** ***
13 : 18 : 08
PROGRAM O0040 N00012
O0040 ;
N10 G92 X0 Y0 Z0 ;
%
LIB
C.A.P
(OPRT)
_
N12
PRGRM
10
D In the example above, if
N12 is not necessary in the next block,
pressing the
DELETE
key after N12 is displayed deletes N12.
D To insert
N100 in the next block instead of N12, enter N100 and
press
ALTER
after N12 is displayed. N100 is registered and initial
value is changed to
100.

Leave a Reply

Your email address will not be published. Required fields are marked *