FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
10. CREATING PROGRAMS
B–62754EN/01
616
O1234 ;
N1 G50 X100000 Z200000 ;
N2 G00 X14784 Z8736 ;
N3 G01 Z103480 F300 ;
N4 M02 ;
X
Z
P0 (100000,200000)
P1
P2
(10000,103480)
(14784,8736)
1 Set the setting data SEQUENCE NO. to 1 (on). (The incremental
value parameter (No. 3212) is assumed to be “1”.)
2 Select the
TEACH IN HANDLE mode.
3 Make positioning at position
P0 by the manual pulse generator.
4 Select the program screen.
5 Enter program number O1234 as follows:
O
1
2 3
4
INSERT
This operation registers program number O1234 in memory.
Next, press the following keys:
EOB
INSERT
An EOB (;) is entered after program number O1234. Because no
number is specified after N, sequence numbers are automatically
inserted for N0 and the first block (N1) is registered in memory.
6 Enter the
P0 machine position for data of the first block as follows:
G 5
0
INSERT
X
INSERT
Z
INSERT EOB INSERT
This operation registers G50 X100000 Z200000 ; in memory. The
automatic sequence number insertion function registers N2 of the
second block in memory.
7 Position the tool at P1 with the manual pulse generator.
8 Enter the
P1 machine position for data of the second block as follows:
G
0 0
INSERT
X
INSERT
Z
INSERT EOB INSERT
This operation registers G00 X14784 Z8736; in memory. The
automatic sequence number insertion function registers N3 of the
third block in memory.
9 Position the tool at
P2 with the manual pulse generator.
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *