FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

OPERATION
B–62754EN/01
10. CREATING PROGRAMS
617
10 Enter the P2 machine position for data of the third block as follows:
G
0
1
INSERT
Z
INSERT
F 3
0 0
INSERT EOB INSERT
This operation registers G01 Z103480 F300; in memory.
The automatic sequence number insertion function registers N4 of the
fourth block in memory.
11 Register M02; in memory as follows:
M 0
2
INSERT EOB INSERT
N5 indicating the fifth block is stored in memory using the automatic
sequence number insertion function. Press the
DELETE
key to delete it.
This completes the registration of the sample program.
The contents of memory can be checked in the
TEACH IN mode by using
the same procedure as in
EDIT mode.
PROGRAM O1234 N00004
(RELATIVE)(ABSOLUTE)
U –85.216 X 14.784
W –191.264 Z 8.736
O1234 ;
N1 G50 X100000 Y0 Z20000 ;
N2 G00 X14784 Z8736 ;
N3 G01 Z103480 F300 ;
N4 M02
%
THND
* * * *
* * * * * *
14 : 17 : 27
LIB
(OPRT)
;
_
PRGRM
When a value is keyed in after keying in address
X
,
Z
, or
Y
,
then the
INSERT
key is pressed, the value keyed in for a machine position
is added for registration. This operation is useful to correct a machine
position by key–in operation.
Commands to be entered before and after a machine position must be
entered before and after the machine position is registered, by using the
same operation as program editing in
EDIT mode.
Explanations
D Checking contents of the
memory
D Registering a position
with compensation
D Registering commands
other than position
commands

Leave a Reply

Your email address will not be published. Required fields are marked *